Wireless AutoSwitch for Vista & XP
Size: 2.37MB - Link rapidshare & megaupload

Wireless AutoSwitch runs as a service and will automatically disable your wireless card when you connect to a LAN (hard wire) connection, and re-enable the wireless card when there is no LAN connection. This ensures that you are always using the fastest connection for network traffic. In the office this helps reduce redundant network connections, while still helping your employees seamlessly transfer from wired to wireless network connections.

For offices that are wireless security conscious this application makes sure the laptop’s wireless card is off when the user is wired into your network.

What it Does:

Wireless AutoSwitch is installed and runs as a service that is set to automatically start. If the user stops the Wireless AutoSwitch program, it will restart automatically on reboot.

The first thing it does is identify the wireless card and then finds out if it is enabled or disabled. Then it checks if there is a hard-wire connection active. If there is an active wired connection the wireless card is disabled if it isn’t already disabled.

At this point Wireless AutoSwitch is in a loop looking at the wired connection every 3 seconds.

Because the program is in a loop only looking at the wired connection you can manually enable the wireless card and it will not get automatically disabled by Wireless AutoSwitch (Only in Mode 1 and 3). This is useful if you temporarily want both wired and wireless enabled.

The moment the wired connect is disconnected, the wireless card is enabled and Windows takes over and makes a wireless connection if one is available and setup for automatic connection.

Wireless AutoSwitch will only enable or disable the wireless network card depending on the situation and nothing else. It does not establish the wired or wireless connections, Windows does that.

Windows XP Version
Wireless AutoSwitch for Windows XP has 4 different modes. Each mode does something a little different. The default installation mode is Mode 1.

Mode 1:
Starts when windows starts however it waits for the user’s desktop (Program Manager) to be loaded before it actually enable or disable the wireless card.
Installs a shortcut called “Wireless AutoSwitch On-Off” so the user can manually turn it off and on.
User can manually enable the wireless card and Wireless AutoSwitch will not automatically turn it off.

Mode 2:
Starts when windows starts however it waits for the user’s desktop (Program Manager) to be loaded before it actually enable or disable the wireless card.
No shortcut created.
If the user manually enables the wireless card Wireless AutoSwitch will automatically turn it off.

Mode 3:
Starts when windows starts, does not waits for the user’s desktop (Program Manager). ***May slow down Windows Start Up time.
Installs a shortcut called “Wireless AutoSwitch On-Off” so the user can manually turn it off an on.
User can manually enable the wireless card and Wireless AutoSwitch will not automatically turn it off.

Mode 4:
Starts when windows starts does not waits for the user’s desktop (Program Manager). ***May slow down Windows Start Up time.
No shortcut created
If the user manually enables the wireless card Wireless AutoSwitch will automatically turn it off.

Windows Vista Version

Wireless AutoSwitch for Windows Vista has 2 different modes. Each mode does something a little different. The default installation mode is Mode 1.

Mode 1:
Starts when windows start.
User can manually enable the wireless card and Wireless AutoSwitch will not automatically turn it off.

Mode 2:
Starts when windows start.
If the user manually enables the wireless card Wireless AutoSwitch will automatically turn it off.

Your Download-Link:ong8ba8WirelessAutoSwitch.zip

Similar Posts :